Check The Efficiency Of Your Boiler Before Winter Starts
Boilers make it easier to survive and stay warm during the freezing winters. This is why it is best to plan and ensure that your heating systems work efficiently and will not pose a problem during these months. To keep them in perfect condition is by maintaining them. So here is a guide on how you can ensure that your boilers are working efficiently.
1) Get service done annually
It is important to get your boilers checked by certified engineers annually. They will check every boiler area, clean all the parts, review logs, and correct what's wrong. They will also report you on the fuel consumption and the gas temperature. Evaluation of the boiler will help engineers to determine if a problem can be caused later on. An old boiler is likely to break down and be less efficient during the cold season. So you should consider upgrading to a more efficient boiler if needed and use Utility Bidder to get the best gas tariffs and reduce your bills.
2) Watch out for warning signs
Various pronounced warning signs show themselves and indicate a faulty boiler that may cause serious harm. These signs include the following:
Cracks
Leaks
Soot or black marks
Odors
Gas or fumes
Sound
3) Regularly run your boiler
Boilers are closed off during the summer months. This is why your trial must run the boiler to ensure it is working properly and efficiently. If there is a problem, then it can be corrected on time before the start of winter.
4) Install Carbon monoxide detector
You have to watch out for this gas. It has been named the "silent killer" because it is a clean and tasteless gas. This gas can start being produced in your boiler if it is not working properly and there is some fault. So you must have a carbon monoxide detector installed with an alarm to notify you in case the gas starts producing. Its emission would mean the boiler is faulty.
5) Bleed the radiators
Once you switch on the heat, you should check whether the bottom is colder than the top. If the bottom is colder, then it means that there is air trapped in the system. It is crucial to release this trapped air as it can cause stress on your boiler and thus waste energy. So you need to bleed the radiators by following the steps below:
Switch off the heat
Put the key in the bleed valve and turn it 25% counterclockwise
You will hear a hissing sound, and the water will also drip out of the bleed valve
Once it settles, lock it again
6) Check the flame
The boiler that works efficiently without any problems is the one that has a blue flame burning in the pilot. If the pilot light is burning any color other than the blue flame or is regularly going out, this could mean something seriously wrong with your boiler. And you should promptly get it checked before the cold season arrives.
In conclusion
So these are some of how you can ensure that your boiler is working efficiently and will be with you during the cold months. It is best to prepare ahead of time. Before the winter season starts and the need for a boiler sets in, you should get your boiler checked by experienced engineers. And follow the points mentioned above to ensure that your boiler is ready for winter.